How should I fix the aluminum plastic board on the rough wall surface?

The aluminum-plastic plate, as the black horse in the decorating building business, is getting more and more attention and use, and the market is heating up, which benefits from the expansion of the real estate sector and the improvement of people's living standards.

Simultaneously, Julong interior composite wall panel swiftly won the hearts of many consumers due to its superior performance: it is waterproof and moisture-proof, insect-proof, pressure-resistant, easy to clean, and has strong ornamental qualities, among other things.

In the sales process for indoor aluminum-plastic plates, we frequently hear the following: Aluminum-plastic wall panels are easy to install and can be put directly on walls. The procedure is straightforward and time-saving.

Is that correct? Let's see if it can be fixed to the wall directly

If it is a house project that meets the standards, the most common circumstance at the moment is that an aluminum-plastic panel can be directly installed on the rough wall, which can be directly affixed by using all-purpose adhesive, structural adhesive, or nail-free adhesive if the wall surface is flat enough.

If the wall is not flat enough, you must perform basic surface preparation, install the keel, and employ dry hanging installation.

Basic wall treatment

Although standard-compliant dwellings are popular, there are a few disqualified houses as well. Installing aluminum-plastic composite panels will not produce satisfactory results in this scenario. As a result, before installing aluminum-plastic composite panels, walls must be simplified.

Related knowlegde:How to Install Aluminum Composite Panels on Walls?

1. Treatment of non-uniform blank metope

Because the real size of the rough house is exceedingly uneven, and there are variations between the upper and lower walls, the wall will be successfully rehabilitated, and the region will be trimmed with the least amount of bend. The fulcrum is paved with hardwood slats and has a maximum point deviation of 2-3 cm. To be consistent both up and down, and then to be on the keel

2. There are bumps in the wall

If the wall bump is too large, it will have a direct impact on the actual installation effect. At this point, the water level meter must be utilized for leveling, and the woodwork strip should be used as the installation site.

3. The projecting wall of the column is filled with a wooden keel

You can set a 300 mm by 300 mm spacing between the tessellation grids.